DN5 Series

Metal to Metal Seated Hydraulic Solenoid Pilot Valve

The stainless steel design ensures a leak tight shut off. Incorporating a balanced internal piloting system enables the low powered solenoid coil to switch the valve at high pressures.
The DN5 Pilot and Mainstage use cartridge insert technology which simplifies replacement and considerably reduces "downtime" costs.
Features of the DN5 are an 'O' Ring interface that enables it to be fitted with a subplate, or manifold mounted for use in local control panels for actuators and wellhead control applications.
By removing just 4 bolts the valve can be dismounted without disturbing pipework and possibly contaminating the hydraulic system. Blanking or flushing plates can also be supplied.

• Specifically designed for Offshore Severe Environments
• Certified Zone 1 Hazardous Areas
• ATEX 94/9/EC
• M.T.B.F, SFF, PFD and SIL Data (Available upon request)
• Easy installation, Repair and Replacement
• Ambient Temperature Range -50°C to 60°C
• Low Power Consumption (3.5 Watts)
• 316 Stainless Steel Construction
• 690 bar Max Pressure
• Leak tight

	DN5 Series Hydraulic Interface Control Valve
	High Pressure Hydraulic Interface Valve This is a rugid piston operator and ball seated design, ensuring a leak tight shut offf and positive control. The valve can also be supplied with a variety of operators, for a range of pressures and ambient temperatures (see selection chart). The DN5 High Pressure Hydraulic Interface Valve can be individually in-line mounted or subplate/multi-station manifold mounted with integral cartridge check, flow control, and pressure relief valves, to provide a compact, cost effective, weight and space saving solution, for multi-well panels. Flow Rate 15 (lpm) Minimum Air Pilot Pressure 2.0 bar (44 psi) Filtration Recommended 10 micron absolute Ingress Protection IP66/NEMA 4X Nominal Flow Rate 15 LPM @ bar DP; Cv = 0.33 Ambient temperature range Standard -20 to +60; Low Temp -50 to +60 (°C) Maximum Air Pilot Pressure 12 bar (174 psi) Materials of Construction 316L Stainless Steel body; Wetted parts: stainless steel; Seals: Rubber (viton/PTFE) Ports NPT Hydraulic Port Connections 1/4" NPTF; Air Pilot Port Connection 1/4" NPTF Operating pressure range 0 to 690 bar depending on operator type Fluid Media Suitable for use with Mineral Oil, Synthetic Oil, and Water Glycol Fluids
	DN5 Series IECEX
	IECEX compliant Hydraulic Solenoid Pilot ValveThis is the IECEX compliant version of the DN5 series metal to metal seated hydraulic control valve. It's stainless steel design ensures a leak tight shut off, while incorporating a balanced internal piloting system to enable the low powered solenoid coil to switch the valve at high pressures. Filtration Recommended 10 micron absolute Flow Rate 20 (lpm) Materials of Construction Valve bodies and subplates 316L Stainless Steel; Wetted parts, various grades of stainless steel/ ceramic/ aluminium bronze; Metal to metal seated design Ambient temperature range Standard -20 to +60; Low Temp -50 to +60 (°C) Ingress Protection IP67/NEMA 6 Operating pressure range 0 to 690 bar depending on operator type Fluid Media Suitable for use with Minerals Oils, Water Glycols and Synthetic fluids

 DN5 series hydraulic solenoid valve
 DN5 series hydraulic solenoid valve
 DN5 series iecex hydraulic solenoid valve