DN10 Series

Metal to Metal Seated Hydraulic Solenoid Pilot Valve

The stainless steel seat design of this valve ensures a leak tight shut off. The design incorporates a balanced internal piloting system to enable the low powered solenoid coil to switch the valve at high pressures.
The DN10 Mainstage uses cartridge insert technology which simplifies replacement and considerably reduces "downtime" costs. Features of the DN10 are an "O" Ring interface that enables it to be fitted with a subplate, or manifold mounted for use in local control panels for actuators and wellhead control applications.
By removing just 4 bolts the valve can be dismounted without disturbing pipework and possible contaminating the hydraulic system. Blanking or flushing plates can also be supplied.

• Specifically designed for Offshore Severe Environments
• Certified Zone 1 Class 1 Hazardous Areas
• ATEX 94/9/EC
• M.T.B.F., SFF, PFD and SIL Data (Available upon request)
• Easy installation, Repair and Replacement
• Ambient Temperature Range -50ºC to 60ºC
• Low Power Consumption (3.5 & Watts)
• 316 Stainless Steel Construction
• 690 bar Max Pressure
• 50 litres/min
• Leak tight

	DN10 Series IECEX
	IECEX compliant hydraulic solenoid pilot valve Ingress Protection IP67/NEMA 6 Certification IECEx BAS.070029x;ATEX 94/9/EC Materials of Construction 316 Stainless Steel Construction Filtration Recommended 10 micron absolute Operating pressure range 0-690 bar Fluid Media Suitable for use with Mineral Oils, Water Glycols and Synthetic fluids Flow Rate 40 (lpm)

 DN10 series hydraulic solenoid valve
 DN10 Series (iecex)